Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OPERATING INSTRUCTIONS
METALLPRINT SP
Manual Name Plate Detail Marker
6. Adjustment of Marking Depth and Pressure Control
By means of the screw (2) at the upper side of the machine, the marking depth and
respectively the position of the pressure point are limited. This adjustment allows an exact
setting of the marking depth. Even when the hand lever is strongly depressed, the
marking pressure is limited, so that any unnecessarily deep marking and thus any
deformation of the name plate is avoided.
By turning the screw (2) to the left the pressure point is lowered, viz. closer to the marking
table (12), until the marking wheel hits the marking table.
Therefore, never operate the lever (1) without a plate lying under the marking wheel!
By that you prevent damage to the marking table, which would be disadvantageous to the
marking of very thin plates (1/10 mm).
By turning the screw (2) to the right the pressure point is raised, viz. the space between
marking wheel and table is increased (max. 4 mm) in the lowest position of wheel (hand
lever (1) depressed).
- 6 -
Werbung
