Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OPERATING INSTRUCTIONS
METALLPRINT SP
Manual Name Plate Detail Marker
1. Installation
After removing the packing material from the machine, the marking table (12) must be
fitted. It is to be inserted into the table-guidance (14) from the r i g h t and then pushed
into the marking machine. While doing this, take care that the pin (8) situated below the
table (12) in the front to the left will fit into the loop (16) of the return spring (15).
After that place the machine on its back and push the table (12) further to the left, until the
first teeth of the rack (20) catches into the gear wheel (17). Now screw the stop screw (18)
delivered with the machine into the provided threaded hole in the bottom of the table and
tighten the screw. Put the machine in upright position again and it is now ready for
operation.
2. Fitting of Marking Wheel
The marking wheel (5) is placed on the pivot – with the white visible marks (4) ahead –
and secured by the disk (7) and the knurled screw (6). The desired figures or letters are
adjusted by turning the wheel (5) at the knurled knob until the marking arrow (3) above the
marking wheel shows to the desired symbol.
- 4 -
Werbung
