Service / Maintenance; Service & Maintenance - Aquis Claris SCOUT Installations- Und Bedienungsanleitung

5.4 Count reading (when inserting the fi lter)
It is possible to call up total count reading during the exchange of the last five filter installed individually.
Step Button
1.
2.
5.5 Alarm
Step Button
1.
2.
3.
5.6 a Setting unit (Liter or gallon)
Step Button
1.
2.
3.
5.6 b Setting pulses per liter
Calibration factor to be able to use other sensors.
Step Button
1.
2.
3.
4.
The standard is 740 pulses per liter

6. Service / Maintenance

Check the SCOUT flowmeter for leaks daily.
In the event of a fault, please contact your service contractor.
Press and hold the „MENU" button for approx. 5 sec.
- The digit „-1" appears = Total count reading at the
penultimate exchange of a filter
Press the „MENU" button once
- The digit „-2" appears, press until „-4" possible
Press and hold the „MENU" button for approx. 5 sec.
- „Beep on" or „Beep off" flashes
Press the „MODIFY" button once
- Change in „Beep on" or „Beep off"
Press the „MENU" button once
- The programmed value appears
Press and hold the „MENU" button for approx. 5 sec.
- „L" or „Gal" flashes
Press the „MODIFY" button once
- Change in „L" or „GAL"
Press the „MENU" button once
- The programmed value appears
Press and hold the „MENU" button for approx. 5 sec.
- „L" or „Gal" flashes
Press and hold the „MODIFY" button for approx. 10 sec. again
- „Pulses per liter" appears - Active digit flashes
Press the „MODIFY" button
- Setting the active digit
Press the „MENU" button - to confirm the desired digit and
move to the next digit
- Active digit flashes (process belongs to the last digit)
11
Display
Display
Display
Display