How Does Your E-Kick2 Work; How To Ride - Oxboard E-KICK2 Benutzerhandbuch

4. HOW DOES YOUR E-KICK2 WORK?

4.1 How to ride

1. Turn on the scooter by press 2S and check the battery power.
2. Once the power is on, it is safer to start riding with one
foot on the deck keeping the other foot on the ground for
pull off, once you're at speed 5km/h, push the accelerator
and place the other foot on the deck, this is safer and more
controlled than pulling off with two feet on the deck as
you will have less control and stability with two feet on the
deck. Use the accelerate throttle valve to speed up or slow
down when riding.
Warning: There is risk of falling down during learning, so make sure to wear helmet and protection kits all the time. Be aware of your surroundings. If
scooter has both electric brake and rear physic brake, the electric brake is prior to rear brake, which is only used as auxiliary brake when electric brake
does not work properly. DO NOT step on rear brake for a long time. Or it will break the tire and fender.
3. To stop riding, release the throttle and use the
electric handbrake to gradually coast to a stop then
step off the scooter one foot at a time. Be extra
cautious when dismounting for the first time.
4. Turn off the scooter when you're not using the device.
7