Charging Your E-Kick2 - Oxboard E-KICK2 Benutzerhandbuch

9. CHARGING YOUR E-KICK2

Step 1: Ensure that the charging port is clean and dry.
Step 2: Plug the charger into the power socket, then connect the cable with the power supply (100V～240V;
50,60Hz, make sure the light on the charger is lit GREEN.
Step 3: Male DC connector plug into the charging port of the E-Kick2. The indicator light on the charger
should change to RED, indicating that your E-Kick2 is now, being charged. When the RED indicator light on
your charger turns to GREEN then your E-Kick2 is fully charged. This will usually take 4 hours. Once your E-
Kick2 is fully charged, please unplug from the charger.
Step 4: Please unplug the charger from your E-Kick2 and from the power outlet.
IMPORTANT NOTES ABOUT CHARGING: If the green light on your charger does not turn RED when you plug it into
your E-Kick2, it could mean you have to check the cables to ensure you have a proper connection; or that your scooter
is already fully chaged.
Do not overcharge, as this will affect the battery life.
•
The best charging temperatures are between 0°~40°. Extreme cold and extreme heat will prevent your battery
•
from charging fully.
• Make sure to unplug your charger before standing on or operating you E-Kick2, as this can be very dangerous.
Use only the scooter charger that you received in your box.
•
If the E-Kick2 is powered on when you enter the plug, the Battery Indicator will begin blinking, if the E-Kick2 is
•
powered off when you enter the plug, the Battery Indicator will not blink.
NOTE: Only the indicator light on the charger will tell you the status of the battery during charging.
12