8
Resetting to the initial state
The device can be reset to the initial state. Doing this deletes all
information relating to taught-in components.
To reset, proceed as follows:
• Press and hold down (for more than 4 seconds) the channel
button to switch the device to teach-in mode.
• The light flashes briefly. Press the channel button again,
releasing it more quickly this time (within 4 seconds).
• The device switches to teach-in mode for the light flash
channel. Press and hold down the channel button again (for at
least 4 seconds).
• The device LED flashes quickly to indicate that the actuator
has been reset to the initial state.
9
Device LED feedback
Various actuator states are indicated by the channel LED
flashing:
Slow flashing
Fast flashing
One long flash, n brief flashes (depending
on the type of error)
Teach-in mode
Reset
Error
19