6
Start-up
6.1
Start-up
To start up the device, simply plug it into a socket outlet in the
indoor 230 V mains power supply.
Press the channel button to operate the actuator and check that
everything is in working order.
Simply press and release the button (within 4 seconds)
to control the actuator. Pressing and holding down the
button (for more than 4 seconds) will switch the actuator
to teach-in mode.
6.2
Teaching-in
Please read this entire section before starting the
teach-in procedure.
In order to enable communication between radio components, the
devices have to be taught-in to one another. To execute the teach-
in procedure, both of the devices to be linked must be in teach-in
mode.
The radio chime with light flash does not have a special teach-in
button. It has one channel for the light flash and another for the
chime. To trigger both the chime and the light flash, a transmitter
(e.g. a door/window contact) would have to be taught-in
separately on both channels. To teach-in, proceed as follows:
• Press and hold down the channel button on the radio chime for
at least 4 seconds.
• The light flashes. To activate teach-in mode for the light flash
channel, press (short keystroke) the channel button briefly at this
point.
17