Operation - HomeMatic HM Bedienungsanleitung

• If you do not press the button, an audible signal (chime) will
sound after 10 seconds. This indicates that teach-in mode can
now be activated for the chime channel. To activate teach-in
mode for the chime channel, press (short keystroke) the channel
button briefly at this point.
• If another 10 seconds passes without the button being pressed,
the device will return to the selection of the light flash channel.
• When the light flash or chime signal channel is selected, the
device flashes continuously to indicate that teach-in mode has
been activated.
• Teach-in mode remains activated for 10 seconds. If another
HomeMatic component outputs a teach-in signal during this
time, the two devices will be taught-in to one another.
7

Operation

After teach-in has been performed, a simple operator function is
available via the taught-in HomeMatic components. Depending
on which channel (light flash/chime) a device has been taught-in,
a corresponding visual and/or audible signal is output.
The actuator does not have a special teach-in or operating
button. Press (short keystroke) the channel button briefly to
activate the light flash and the chime directly on the device
(1 chime, 6 light flashes).
18