Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Decorative cap
Made of Polished stainless steel 04X18H10
Inner stud-bolt, М8 screw
Made of Polished stainless steel 04Х18Н10
Mounting disk
Made of Polished stainless steel 04Х18Н10
Inner stud-bolt with locking screw
Made of Polished stainless steel 04Х18Н10
Dowel + self-tapping screw
www.sunerzha.eu
Screw in the decorative cap
into the adapter coupling G ½"
Repeat the same sequence for
the second collector.
Using a screwdriver screw in
four stud-bolts into the anchoring
points on the rear side of the collector.
Apply the radiator to the wall in desired
position and mark anchoring points.
Drill holes in the marked positions,
insert dowels and apply mounting disks
to the drilled hole. Insert wall-bracket
hub with locking screw in the center of
the disk. Fit the four mountings to the
wall self-tapping screws.
Install the radiator on the wall by putting
the pin in the center of mounting disk.
Connect the radiator to the pipeline.
EN
6
7
8
9
10
6
Werbung
