Audio - PATONA Premium Serie Handbuch

LCD 3G-SDI MONITOR 7"
- Timecode -
The type of timecode can be selected to display on the screen. [VITC] or [LTC] mode.
Note! Timecode is ONLY available under SDI mode.

3-1-5. Audio

- Volume -
Adjust the volume from [0]-[100] for the built-in speaker and the earphone jack audio signal.
- Audio Channel -
The monitor can receive 16 audio channels from the SDI signal. The audio channel can be changed
between [CH0&CH1], [CH2&CH3], [CH4&CH5], [CH6&CH7], [CH8&CH9], [CH10&CH11],
[CH12&CH13], [CH14&CH15]
Note! Audio Channel is ONLY available under SDI mode.
- Level Meter -
The left side of the on-screen meter displays the audio levels for channel 1 and 2 of the input source.
It features a peak hold indicator which stays visible for a short time. So, the user can clearly see the
maximum levels reached.
To achieve optimum audio quality, ensure the audio levels do not reach 0. This is the maximum
level, meaning that any audio singnal that exceeds this level will be clipped and results in distortion.
Ideally peak audio levels should fall in the upper end of the green zone. If the peaks enter the yellow
or red zones, the audio is in danger of clipping.
- Mute -
Disables any sound output.
17