Power Switch - Spectro-UV SPECTROLINE EDGE 13 Bedienungsanleitung

HOUSING MAINTENANCE
The lamp housing is designed for the protection of internal parts. After unplugging
the unit, clean spills on the outer housing with water and a mild detergent.
Wipe the unit dry. After unplugging, periodically clean the clear protective glass
filter with a cleaner and a soft cloth.
CONNECTING THE EDGE™ 13
Connect the AC Control Box to the EDGE™ 13 by securing the male-to-female
connections. Align the male-to-female connectors and turn the adjustable housing
of the connector clockwise to tighten and secure the connection. Use the Gangable
Connector to connect multiple EDGE™ 13 units together. Assure the connections
are secure before using the AC Control Box to turn the unit ON.
Female Power
Connector
Receiving
Male Port

POWER SWITCH

The EDGE™ 13 comes with a two-position rocker switch (O = off and I = on).
Prior to plugging the unit into a grounded receptacle, ensure that the power switch
is in the OFF position. Push the power switch to the ON position. Instant-on
operation ensures that each of the UV-A LEDs reaches full intensity very quickly.
Check to see if the unit is operating optimally.
CLEAR GLASS FILTER PROTECTOR REPLACEMENT
A set of detailed instructions for Replacing the Clear Glass Filter Protector comes
with the ordered replacement parts. Contact Customer Service for more details.
Call toll-free 1-866-230-7305.
REPLACING THE UV-A LENSES
The UV-A lenses covering the three UV-A LEDs must be replaced over time.
They will solarize (become cloudy and yellow) from repeated use. A set of detailed
instructions come with the replacement UV-A lenses. See Replacement Parts
section and contact Customer Service for more details.
Two-Position Rocker Switch
4
Female Port for
Ganging Units
Together