About This Guide; Unpacking The Product; Product Overview - D-Link DSR-500 Installationsanleitung

About This Guide

This guide gives step by step instructions for
setting up D-Link DSR-500/1000 Unified Services
Router. Please note that the model you have
purchased may appear slightly different from those
shown in the illustrations.

Unpacking the Product

Open the shipping carton and carefully unpack its
contents. Please consult the packing list located
in following information to make sure all items are
present and undamaged. If any item is missing or
damaged, please contact your local D-Link reseller
for replacement.
- One (1) DSR-500/1000 Unified Services Router
Appliance.
- One (1) Power Cord
- One (1) Console Cable (RJ45-to-DB9 Cable)
- One (1) Ethernet (CAT5 UTP/Straight Through)
Cable
- One (1) Reference CD (CD-ROM containing
product documentation in PDF format)
- Two (2) Rack Mounting Brackets

Product Overview

Front Panel - DSR-500/1000
A B
Figure 1. DSR-500/1000 Front Panel
Note: DSR-500 supports one USB port only.
2  D-Link Unified Services Router
C D E
Item Feature Description
A Power LED Indicates the Unified Services
Router is powered on.
B USB Ports (2) It can support various USB 1.1 or
2.0 devices below:
1. Flash Disk or Hard Disk for
network sharing.
2. 3G Adaptor for WAN redundant
(Available on DSR-1000 only)
3. Printer (It will be supported by
future firmware upgrade)
C Gigabit LAN port Connect Ethernet devices, such as
(1-4) computers, switches and hubs.
D Gigabit WAN port Two auto MDI/MDIX WAN ports
(1-2) are the connection for the Ethernet
cable to the cable or DSL modem.
The WAN2 port is a configurable
port which can support WAN2 or
DMZ port for dual WAN connec-
tions or internal Server Farm
purpose.
E Console Port Used to access Command Line
Interface (CLI) via RJ45-to-DB9
console Cable.
Table 1. DSR-500/1000 Front Panel Descriptions
Device Status LEDs and Ethernet Port LEDs
Link
Speed
Figure 2. Ethernet RJ-45 Port LEDs
The device LEDs show information about current
device status. When the device power up, the
POWER/STATUS LED will show solid orange
during power on process. Startup takes one minute
approximately to complete, the LED will change
to solid green. If you want to turn the device off
and on again, we recommend you wait a few
seconds between shutting it down and powering it
back. The Ethernet LEDs show the status of each
Ethernet port. Table 2 lists the name, color, status
and description of each device LED.
TX/RX
Status