Installation Instructions - Gima 43260 Bedienungsanleitung

13

2.Installation instructions

2.1 Installation and commissioning of the wheelchair
1. The initial installation of the parts must be completed by the technical personnel approved
by the company.
2. In general, wheelchairs are installed when they leave the factory, folding and packing, and
pedals are placed separately. List of frame bodies and spare parts:
Item Fitting Name
1 Folding frame body
2 Movable leg (including pedals)
3 Homemade wrench
4 bottom bands of trouser legs
3. Here are two simple steps to prepare wheelchairs for use:
Step 1: expand
Hold the hand with both hands so that the left and right frames are slightly separated. When
the two sides of the seat cushion are lightly pressed to the level of the seat cushion with the
hand, the wheel chair is deployed. (as shown in Figure 1)
Note: when unfolding, do not pull the left and right frame hard, so as not to damage the parts.
When pressing the seat pad down, do not hold the finger to the seat pipe so as not to clip
the finger.
Figure 1
Step 2: when installing the movable leg to install the movable leg, first align the
positioning hole on the movable leg and the lower bracket on the frame, lower fixed pin, hang
on the movable leg, rotate the movable leg from outside to inside with light force to reach the
self-locking state of the fastener spring. (figure 2)
2.2 The use of a wheelchair
1. The method of pushing wheelchair by oneself
The user sits stably in the wheelchair, and then holds the handwheel of the left and right
rear wheels with his hands. Both hands push forward at the same time to make the wheel-
chair go forward, release their hands, and repeat the above steps when the speed of the
wheelchair slows down for a certain distance and needs to be pushed again. (figure 3)
ENGLISH
Quantity
1
1 pair
1
1
Figure 2