Herunterladen Inhalt Inhalt Diese Seite drucken

GRAPHITE 58GE105 Originalbetriebsanleitung Seite 6

Werkstattstaubsauger
Inhaltsverzeichnis

Werbung

WARNING! Observe the safety regulations when using the vacuum
cleaner. For your own safety and that of third parties, please read
this manual before you start working with the blower. Please keep
this manual for future reference.
• This tool is not intended for use by people (including children) with
reduced physical, sensory or mental capabilities, or people with no
experience or knowledge of the equipment, unless it is done under
the supervision or in accordance with the instructions for use of the
equipment provided by persons responsible for security.
• REMEMBER. The operator or user is responsible for accidents or
hazards to other people or the environment.
Preparation
• Always wear sturdy shoes and long pants when working.
• Always use personal protective equipment such as safety glasses.
• Before starting work, carefully check the working environment and
remove any objects that may be sucked in or thrown away by the
blast of vacuum cleaner air.
A - Dust collector latch
B - Top of the vacuum cleaner
C - Dust collection tank
D - Triangular brush
E - Sponge filter
F - Suction hose holder
Use
Before working with this device, read the detailed instructions, especially
the battery, charger and accessories.
Do not operate this unit with wet hands to prevent electric shock.
Make sure that the battery socket and charger are always dry to prevent
any electric shock.
Do not charge the battery in a damp or wet place. Do not use, store or
charge it in places where the temperature is less than 10 ° C (50 ° F) or
above 38 ° C (100 ° F). Do not store the battery outdoors or in vehicles.
Take it out the battery from the device when the device is not in use and
before any servicing.
When the battery is not in use, keep it away from other metal objects, such
as: paper clips, coins, keys, nails, screws or other small metal objects that
may short-circuit the poles. Shorting the battery terminals together can
cause arcing, burns, or fire.
Do not use a damaged or modified battery.
Do not overturn or turn the device as dust and liquids may enter the
internal structure through the air inlet.
Any damaged parts should be replaced or repaired by an authorized
service center and qualified technicians.
Keep hair, loose clothing, fingers and all parts of the body away from the
openings and moving parts of the vacuum cleaner.
Do not use the device to pick up hot water / liquids, flammable objects or
flammable liquids (e.g. cigarettes, matches, explosives or burning items,
ashes).
Note the maximum length that the flexible hose can reach. Maintain proper
position and balance at all times when using the machine.
Never vacuum dry dust and debris without the HEPA filter in place.
• Remember to clean the tank, filter, flexible hose and accessories
after use. If the machine does not work or there are any technical
problems, please contact your local stores or call our customer
service hotline for assistance.
• Always work while wearing long trousers and solid footwear.
• Work only in daylight or with very good artificial lighting.
• Always make sure your legs are standing firmly. Work carefully on
sloping surfaces to avoid losing your balance.
• Do not attempt to work without the hose accessories and handpieces
installed.
• Make sure that the ventilation holes in the case are free from debris.
• Do not share the garden tool for use by children or people who have
not read this manual.
• Do not continue working with bystanders, children or pets in the
immediate vicinity
• Do not direct the blast of air and leaves towards people.
• When working, hold the vacuum cleaner firmly, keep a stable position
when working.
Maintenance and storage
• Maintain all components in good condition to ensure that your garden
tool is safe to use.
• Replace worn or damaged parts for safety.
• Keep out of the reach of children.
G - Waterproof battery cover
H - Flexible hose
I - HEPA filter
J - Switch
K - Air outlet
L - Transport handle
M - Slot suction nozzle
ATTENTION! Despite the inherently safe construction, the use of
safety measures and additional protective measures, there is always
a residual risk of injury during work.
Rated data:
Parameter
Supply voltage
Rated power
Tank capacity
Protection class
Level of security
Mass
Year of production
Explanation of the pictograms used
1. Read the operating manual, observe the warnings and safety
conditions contained in it!
2. Disconnect the device from the power supply before repair.
3. Protect the device against moisture.
CONSTRUCTION AND APPLICATION
The battery vacuum cleaner is a hand-held device. The drive is a DC
commutator motor. A battery vacuum cleaner is a device designed for
cleaning works in the house and its surroundings, e.g. paths, driveways,
garages, basements. As a vacuum cleaner it is used for dry and wet work
indoors. As a blower, it is suitable for cleaning and removing leaves,
clipped grass, fallen conifer needles from terraces, roads and paths. This
device is not intended for industrial use and is also intended for outdoor
use.
WARNING! Do not use the device contrary to its intended use.
EQUIPMENT AND ACCESSORIES
1. Flexible hose extending up to 2m
2. HEPA filter
3. Sponge filter
4. Working tips
5. Flexible adapter
6. Transport wheels
PREPARATION TO WORK
ASSEMBLY / DISASSEMBLY OF THE HOSE AND THE WORKING
ENDS
Before starting work with the device, the flexible hose and accessories
should be correctly and firmly connected.
WORK WITH A VACUUM CLEANER
PULL / SUCK FUNCTION
• Take the snake on the right side.
• Place the hose connector on the air intake handle (fig. 1).
• Turn the connector clockwise to lock.
• Connect the dedicated working tip (triangular brush or crevice
nozzle) with the flexible hose to work in specific conditions (fig. 2).
BLOWER FUNCTION
• Connect the hose connector to the air outlet (fig 3).
• Turn the connector clockwise to lock.
• You can connect the nozzle to the slots with a flexible hose for a
stronger airflow (fig 4).
POWER ON
• Press the button of the battery cover, open the cover and connect
the battery to the socket (Fig. 5).
• Close the battery cover for operation.
• Turn the switch to the 'I' position to start the device (fig. 6).
• Turn the switch to the '0' position to stop the machine.
• Switch light is on under normal power.
VACUUM DRY
6
Value
18 V DC
150W
10 l
III
IPX4
3.85 kg
- 1 piece.
- 1 piece.
- 1 piece.
- 2 pcs.
- 1 piece.
- 4 pcs.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis