T.I.P. UV-C-PJ 11W Gebrauchsanweisung Seite 12

WARNING: Unintentional use of the device or damage to the housing can result in
the emission of dangerous UV-C radiation. UV-C radiation can cause damage to
the eyes and skin even in small doses. Never look directly into the UV-C tube when
it is switched on.
WARNING: Do not operate the UV-C emitter when it is removed from the appliance
enclosure.
Notes and instructions with the following symbols require particular attention:
Danger of injury or material damage if this instruction is not complied with.
Danger of electrical shock that can result in injury or material damage if this
instruction is not complied with.
In addition to the basic safety instructions, also comply with the following
instructions to prevent accidents:
WARNING: Before performing any installation or maintenance tasks, disconnect the
electrical devices immersed in the pond from the power source by pulling the plug
out of the socket outlet. Do not operate the pump if there are people in the water.
Switch off the main fuse of the main domestic power supply, before unplugging the
mains cable, if the connection plug or the main power outlet are wet. Never transport
or suspend the device by the mains cable.
1. Never transport and/or hang up the devices on the power cord.
2. Ensure that the voltage specified on the type plate of the device agrees with the
mains voltage.
3. Prior to connecting the device to the mains supply, ensure that the mains cable
and the device are not damaged in any way.
4. The mains cable of the device must form a loop that points downward (DRIP
LOOP) to prevent water from running along the cable and into the socket outlet.
5. The device must have a residual current circuit breaker (RCCB) with a rated
residual current of max. 30 mA connected on the line side. Consult a qualified
electrician.
6. Do not bury the mains cable in the ground; follow the installation instructions
specified in the applicable local regulations. Consult a qualified electrician.
7. Prior to placing the device in service, ensure that the installation has been
properly executed.
8. Install the filter at least 2 meters away from the edge of the pond; ensure that it
is attached in such a manner that it cannot accidentally fall into the water and
that the installation area of the filter cannot be flooded.
9. Do not use or store the device in areas where there is danger of freezing. In
winter the device should be removed, emptied and stored where it is protected
against freezing.
10. Avoid using the devices with caustic and corrosive liquids.
11. The temperature of the pumped liquid must not exceed 35°C (max.) and must
not under range 5°C.
12. ATTENTION! Only use the UVC filter together with the safety transformer
included in the scope of delivery. If there is a defect, the complete UVC unit
must be replaced.
13. ATTENTION: This device consists partially of glass! Handle with care!
2