AsViva EKC4 Betriebsanleitung Seite 50

ASSEMBLY
ATTACH THE ATTACH THE ADJUSTABLE SEAT
Holder
Outer hole
1./2. Lift the bracket (1) inside the seat while pulling the seat slightly forward (2) and make sure you can see two
inner holes. make sure that you can see two inner holes.
3. Mount the seat (3) to the body, first inserting the tabs on the seat back (top) into the slots on the body and the
iron tubes on the seat bottom also into the matching holes on the body.
4. Insert two Ø4x12 round-head screws through the inner holes on the seat board into the car and tighten them.
5. Repeat operation 1 to slide the seat backwards. Make sure you can see the two outer holes. 6.
6. Insert two Ø4x12 round-head screws through the outer holes on the seat board into the vehicle and tighten
them.
NOTE: The seat is adjustable and has three positions. You can move the seat back as your child grows.
WARNING: When you adjust the seat, ensure the seat "snaps" into place or may cause accidents.
50
Outer hole
2
1
3
Seat Bottom View
Seat board
Inner hole
5
Iron pipes
Inner hole
x2
4
Rear Top View
x2
6
Rear Top View