AsViva EKC4 Betriebsanleitung Seite 41

ASSEMBLY
ATTACH THE DRIVE WHEELS
4
5
1. Plug the gearbox onto the rear axle. Pull out the plug on the gearbox housing through the larger hole and
where the battery is located.
2. Connect the cable of the gearbox to the cable in the interior of the vehicle.
3. Put the drive wheel on the rear axle. Make sure that it is aligned with the gearbox housing.
4. Fix the wheel with a Ø12 washer and a lock nut which you also place on the rear axle.
5. Tighten them with a wrench. [TIP: An extra wrench is provided to hold the lock nut on the other side of the rear
axle while you tighten the lock nut on the other side].
6. Finally, clip on / snap in the hubcap.
7. Repeat the same operation on the other side of the vehicle
3
1
2
Rear axle
41