Goboservice DIVUM 50K Gebrauchsanweisung Seite 5

4. MAXIMUM ROOM TEMPERATURE- Place the projector in a place where there
Ta
5. DEGREE OF PROTECTION IP54- The appliance is protected against dust (first
6. DEGREE OF PROTECTION- The device has an IK09 degree of protection against
7. PROTECTION AGAINST INDIRECT CONTACTS (ELECTRIC SHOCK)- It
8. CONNECTION TO THE POWER SUPPLY NETWORK- The connection
9. TEMPERATURE OF THE EXTERNAL SURFACE OF THE APPLIANCE-
Tc
10. MAINTENANCE- Before starting any maintenance or cleaning operation on the
11. PHOTOBIOLOGICAL SAFETY- ATTENTION. Possible emission of dangerous
-5-
is good air flow. Do not use the projector indoors or in semi-enclosed areas which
could cause a rise in temperature and shorten the life of the device.
Do not use the projector if the ambient temperature (Ta) exceeds 40 ° C.
digit 5) and against splashing water (second digit 4).
any external mechanical impacts.
is mandatory to connect to a power supply system equipped with an efficient earthing
(Class I appliance according to the EN 60598-1 standard).
It is also recommended to protect the power supply lines of the projectors from
indirect contacts and / or short circuits to ground by using suitably sized RCDs.
operations to the electricity distribution network must be carried out by a qualified
user.
Check that the frequency and voltage of the network correspond to the frequency and
voltage for which the device is designed, as indicated on the electrical data plate.
The power absorbed is also indicated on the same plate.
Refer to the latter to evaluate the maximum number of appliances to be connected to
the power line, in order to avoid overloads.
If the projector is used in a residential environment, in some cases it may be necessary
to take specific measures to avoid electromagnetic interference to radio receivers.
The maximum temperature that can be reached on the external surface of the
appliance, in conditions of thermal regime, is <60 ° C.
projector, disconnect the power supply from the mains.
After turning off the projector, do not remove any part of the unit before 10 minutes
has elapsed to avoid burns.
The lenses must be compulsorily fitted; they must also, if visibly damaged, be
replaced with original spare parts.
Periodically remove and clean the dust filters located in the two air intakes of the
appliance to allow correct ventilation of the product. In case of deteriorated filters,
contact the manufacturer for replacement with original spare parts.
optical radiation from this product. Do not look at the light source. It could damage
your eyes.
WWW.GOBOSERVICE.COM Ist0006 – Rev.0