Goboservice DIVUM 50K Gebrauchsanweisung Seite 10

During the installation / replacement of a gobo inside a projector it is essential, for the correct functioning of
the same, to house the gobo so that THE MOST REFLECTIVE SIDE IS ALWAYS FACING THE LIGHT
SOURCE AND THE BLACK / GRAY SIDE AIMED TOWARDS THE OBJECTIVE (seeFig.9). The
respect of this rule allows the use of the gobos in a correct way avoiding their breaking.
Fig.9
LIGHT SOURCE LED GOBO TARGET
Once you have understood the mounting direction, open the lower cover of the projector using the special
fixings, unscrew the fixing screws and remove the accessory from the body of the projector; the gobo is
supplied mounted on the ring nut and you simply need to place it on the gobo holder which has magnets that
support the ring nut, then reinsert the accessory and close the bottom cover of the projector, also checking
that everything is correctly mounted.
ATTENTION: Care must be taken not to damage, soil or stain the surfaces of the gobo, as this could lead to
visible scratches in projection or even chips which, with the heat developed during projection, could lead to
the gobo breaking.
The installation / replacement of the gobo must be carried out with the projector switched off and
disconnected from the power line.
Should the gobo need to be replaced after use, wait for the internal components to cool.
-10-
Divum 50K