Fein AStx649-1 Originalbetriebsanleitung Seite 14

OBJ_BUCH-0000000078-001.book Page 14 Monday, June 25, 2012 2:32 PM
14 en
Original Instructions – Hacksaw for pipes and profiled sections.
en
Symbols, abbreviations and terms used.
Symbol, character Explanation
Make sure to read the enclosed documents such as the Instruction Manual and the General
Safety Instructions.
Observe the instructions in the text or graphic opposite!
Do not touch the saw blade.
Before commencing this work step, pull the mains plug out of the socket. Otherwise there will
be danger of injury if the power tool should start unintentionally.
Use eye protection during operation.
Use ear protection during operation.
Use protective gloves during operation.
Additional information.
Gripping surface
Confirms the conformity of the power tool with the directives of the European Community.
This sign indicates a possible dangerous situation that could cause severe or fatal injury.
WARNING
Worn out power tools and other electrotechnical and electrical products should be sorted
separately for environmental-friendly recycling.
Product with double or reinforced insulation
Steel
Aluminium
Plastic
Low stroke rate
High stroke rate
Character Unit of measurement,
international
P W
1
P W
2
-1
n /min, min , rpm, r/min
0
V
U
Hz
f
M... mm
Ø mm
mm
mm
kg
L dB
pA
Unit of measure- Explanation
ment, national
W Power input
W Output
rpm Stroke rate at no-load
V Rated voltage
Hz Frequency
mm Size of metric thread
mm Diameter of a round part
mm Maximum outside diameter for pipes/with chain
extension
mm Maximum work piece dimensions
kg Weight according to EPTA-Procedure 01/2003
dB Sound pressure level