Product Characteristics - YATO YG-04680 Originalanleitung

GB

PRODUCT CHARACTERISTICS

Pancake maker is a product designed for frying pancakes. Thanks to uniform plate heating, pancakes may be prepared easier and
faster than when using a frying pan. Correct, reliable and safe operation of the product depends on proper operation, therefore:
Before starting product operation, please read this manual and keep it.
The supplier does not assume any liability for any damages resulting from misuse of the product, failure to follow safety regula-
tions and recommendations specifi ed in this manual. Misuse of the product will also result in loss of guarantee and warranty rights
of the user.
EQUIPMENT
The product is delivered complete and does not require assembly. Therefore, before using the product, it is required to remove
all packing and protection elements for transportation. Some preparatory actions described in the further part of this manual are
also required.
GENERAL USE RECOMMENDATIONS
Product is designed for professional use and should be operated by properly qualifi ed per-
sonnel.
Product is designed only for heat treating of meals placed directly on a heating plate. It is for-
bidden to use product for other purposes, for example as a heater of products kept in a vessel.
Unattended repair, disassembly or modifi cation of product is forbidden. All product repairs
must be carried out by an authorised repair point.
Product should be supervised all the time when operating.
WARNING! During operation the product heats up to high temperature, do not touch the
heating plate and product's walls during operation, it can cause serious burns.
This product is not intended for use by children below 8 years of age and persons with re-
duced physical or mental capabilities and person with no experience or knowledge of the
equipment. Unless they are supervised or trained how to use the product in a safe manner so
that the risks involved are understood. Children should not play with the product. Unattended
children should not perform cleaning and maintenance of the equipment.
Recommendations for the product transportation and installation
NOTE! Product installation and connecting can be done only by qualifi ed personnel.
Product can be placed only on hard, fl at, level and non-fl ammable surface. Substrate should
withstand the weight of appliance itself together with food placed on it.
Provide at least 10 cm space around product's side walls, do not place any materials not
resistant to high temperature above the product. This will allow proper product ventilation. Do
not place the product near edges e.g. of a table.
Do not place any electrical appliances over the product. Water steam is release during op-
eration of product, which may cause a short circuit of the electrical installation resulting in
electric shock.
It is forbidden to drill any hole in the product, nor any other product modifi cation not described
herein.
Product to be carried when cooled, by gripping its housing. Do not displace the product by
pulling the cable cord.
O R I G I N A L I N S T R U C T I O N S
8