YATO YG-04680 Originalanleitung Seite 9

GB
Temperature at the place of installation and use of product must stay within the range
+10 C ÷ +38 C and the relative humidity must be less than 90%, without steam condensation.
O O
Recommendations for connecting the product to power supply
Before connecting the product to power supply, make sure that the voltage, frequency, and
capacity of mains supply correspond to values shown on the product rating plate. Plug must
fi t into the socket. Any modifi cations of plug are forbidden.
Product must be connected directly to a single power outlet. It is forbidden to use extension
cords, socket-outlet adapters and double power outlets. Power supply circuit must be fi tted
with a protective conductor and at least 16 A protection circuit.
Avoid any contact of power cord with sharp edges and hot objects and surfaces. When op-
erating the product, the power cord must always be fully unwound and its position may not
interfere with the operation of product. Laying of power cable cannot result in tripping hazard.
Power outlet should be located in such a place to allow always the possibility of quick discon-
necting the plug of power cord supplying the product. When disconnecting the plug of power
cord always pull the plug housing, never the cable.
If the power cord or plug is damaged, disconnect it immediately from the mains and contact
an authorized manufacturer's service center for replacement. Do not use the product with a
damaged power cord or plug. Power cord or plug cannot be repaired, in case of damage to
these components, replace them with new ones without defects.
Recommendations for using the product
WARNING! Heating plate surface may be hot after the use. Do not touch it as it poses a
threat of severe burns. Wait till the heating plate cools down.
In case of preparing the meals, during which hot portions of food may be thrown around, use
personal protective equipment against burns.
Make sure that the fl oor in the vicinity of product is not slippery. This will prevent the risk of
slipping, which may cause severe injuries.
When preparing meals, observe them all the time and prevent burning. Foodstuff s remained
unattended may be burned, which may cause a fi re or severe burns.
In the course of meals preparation, place surface may be touched only by means of wooden
or plastic tools. Tools should withstand a temperature generated by heating plate. It is forbid-
den to take off and serve the meals using your hand.
If any food waste remains on heating plate during or after preparation of a meal, it should be
removed before preparing next meal. Food waste may be burnt, thus generating a smoke,
unpleasant odour, and also aff ect the taste of a meal prepared. They may also cause a fi re.
To remove it, use tools made of wood or plastics withstanding a temperature generated by
a heating plate. Do not use sharp tools made of metal. Such tools may damage a surface of
heating plate.
If meal preparation requires a fat to be used, spread it on the surface of heating plate using a
soft brush. The product is not intended for preparing meals by deep frying.
O R I G I N A L I N S T R U C T I O N S
9