Magicool DIY Gebrauchsanweisung Seite 20

TROUBLESHOOTING:
If any trouble is encountered whilst operating the Magicool system, please refer
to the section below before contacting your point of purchase.
Problems
The Pump does not work?
The CPU reports high (70c) +
temperatures?
Liquid is leaking from the
pump constantly?
The liquid is getting low, but
there is no leak?
The pressure reducing valve
fizzles?
The pump fizzles when the
mainboard is powered, but
fizzles die down shortly
after?
The heat transfer liquid is
dirty & discolored?
The fan of copper tube
radiator doesn't work?
Disclaimer:
Please read and understand this manual correctly and accurately before installing or
operating this product. By disregarding any instructions of this manual could result
in damage to your computer, loss of data, damage to this product / or personal
injury. We will not be held responsible for any of the above and in proper use of this
piece of equipment.
*All trademarks are registered to their respective owners.
All manuals and user guides at all-guides.com
Check your mains power supply; Check your Molex connector
on the pump is fully connected to the power supply
Check your Pump is working, Check you have used thermal
grease on the water blocks & also check if they have been
mounted properly; Make sure your 120mm fan is wired up to
the system power supply.
Check the fittings of the pumps are fixed properly.
Top the system up with coolant (purchased from your point of
purchase) or distilled water.
This is a normal occurrence.
This is a normal occurrence.
Algae will build up in your system after time; it is recommended
that you replace the Liquid Coolant every 6–8 months.
Check to see if the power connector is connected properly. If
not contact your point of purchase to arrange a new fan.
Problem Solution
20