Magicool DIY Gebrauchsanweisung Seite 11

Liquid Cooling Installation Manual
The working principle of the Magicool DIY liquid cooling set, works on a method
known as "Heat Exchange". When power is sent to the pump, it begins to
circulate the liquid around the system. Liquid coolant is then passed through the
cooling blocks which are attached to your CPU, VGA & Northbridge Chipset
(optional parts), the liquid coolant will then transfer the heat from the heat source
through the cooling blocks and then into the coolant. From there, the water
circulates into the radiator which will then be "Surface Cooled" by the Silent
120mm Fan, and will finally disperse the heat from the Coolant.
Caution: Please read and understand this manual correctly and accurately
before installing or operating this product. By disregarding any instructions
in this manual could result in damage to your computer, loss of data, damage
to this product and/or personal injury.
Thank you for purchasing the "Magicool" liquid cooling DIY product.
NOTICE
• This product is subject to updates or changes without prior notice.
• We are not responsible for any direct, indirect, intended, or unmeant damage to
your computer, loss of use, loss of data, loss of income or profit, and/or personal
injury due to incorrect installation and illegal operation.
• If you do not understand any part of this manual, please contact the technical
support. Without understanding the instructions, the installation is forbidden.
• This set of product is suitable for a STD ATX case or server case.
• Before using this liquid cooling set, please read and keep the manual close
by for reference.
• The working temperature environment of the liquid cooling set is from –10°C
to +40°C.
• If there are any leaks from the liquid cooling system, shut down your pc, and
unplug it and peripherals immediately and check the system carefully.
• Keep the radiator out of direct sunlight and away from any other heat
sources.
• Before using the equipment, please make sure that your power supply is at
least 350W or more for safe operation.
• Hold the Molex when unplugging the power cable. Plucking the power cable
directly is not advised.
All manuals and user guides at all-guides.com
MAGICOOL
Introduction
IMPORTANT NOTICE
®
DIY
11