Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
After installing the CPU-Block, radiator and the pump into the case it is time to connect the single
components to each other. Please trim the tubes due to your personal system.
It is important to straight cut the ends of the tubes. A side cutter is recommended to do so.
The tubes will be connected with the included 1/8" fittings (for pump) respectively 1/4" fittings
(radiator / CPU Block).
The single steps to connect the single components as followed:
Step 1:
From Pump „OUT" to CPU Block
Step 2:
From CPU Block to Radiator
Step 3:
From Radiator to Pump „IN"
It is sufficient to fix hand-screwed only!
Filling up the KIT & Testing Pump
To fill up the water cooling kit you need the shot (included) the coolant (included) a screwdriver
and a bowl or similar.
Step 1:
Please remove the 220 Volt plug from your PC (!)
Step 2:
Remove the 20 (24) PIN power plug of the PSU from your M/B. It is best to remove
other components like HDD from power as well.
Step 3:
Bypass the power plug by connecting the green wire with the black one using a
paper clip for example. This step prevents the M/B for getting electricity but it is still
possible to switch the pump „on" and „off" using the power button at the PSU
All manuals and user guides at all-guides.com
Tubing Installation
17
Werbung
Inhaltsverzeichnis
