Magicool DIY Gebrauchsanweisung Seite 13

Warning: Please take care while installing the CPU-Block. Fixing too hard using tools
might cause damages to the CPU and M/B!
1. Please remove the retention module from the M/B if necessary. The M4 screws have to
be put through the M/B from the bottom side. Please make sure that the washer and the
rubber insulating is placed in between as shown on the picture.
2. Please use the washer on the topside of the M/B as well.
3. Screw the four nuts onto the screws to fix the clip on the M/B.
All manuals and user guides at all-guides.com
Installation of the CPU Block
13