Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation procedure
Confirm the strength of the proposed
1
installation location
Make sure the wall can withstand five times the weight of the LCD
monitor together with the wall mount adaptor.
For details on the mass (weight) of the LCD monitor, refer to the
operating instructions of the LCD monitor.
See the following dimensions diagram and confirm the strength of
the wall surface at the four fitting positions. If the strength is not
enough, apply adequate reinforcement.
2
Fit wall mount adaptor B to wall
Wall mount adaptor B
•
If the wall consists of a material such as concrete and bolts or
nuts must be embedded beforehand, determine the hole
positions by aligning using the actual wall mount adaptor, or
calculate hold positions based on the dimension diagram, and
then embed the 4-mm diameter screw anchor.
Note
Use commercially available screws with standard outside
diameter of 4 mm suited to the wall surface material for installing
the bracket to the wall.
/
111.2 (4
1
)
2
/
106 (4
)
1
4
/
78.5 (3
)
1
8
Use a level, etc. to determine and then
mark a horizontal position on the wall.
Use 4 commercially available screws
with standard outside diameter of 4 mm
to fasten wall mount adaptor B.
Wall attachment holes (at 4 points)
[Unit: mm (inch)]
9
Werbung
Inhaltsverzeichnis
