Euromate Sula Originalbetriebsanleitung Seite 25

3. Timer
4. heat 1000W
5. heat 2000W
6. Window open/Hour
7. Delay Function/Minute
8. 24h Timer Button
9. Mode Button
10. Power Button
11. Weekly timer Week
12. Decorative sheet
13. LED Display
Remote Control View:
► P. 4, item 2
– Remote control, please insert 1 pcs Lithium bat-
tery CR2025 3V.
The explanation on the remote control icon function:
• [ ] Power button
• [24H] Setting timer from 1-24 hours
• [MODE] COLD, WARM, HOT 3 setting for selec-
tion
• [ ] Frost prevention function
• [LOCK] Child-Lock function
• [AUTO] Window Open function
• [Delay] Wake up and set temperature of one
week
• [W.Timer] Weekly timer
• [+] Increase
• [-] Decrease
• [Set] Set real time
Normal Operation Instructions
– Before inserting the plug into an electrical outlet,
make sure that the electrical supply in your area
matches that on the rating label on the appliance.
– Carefully remove the appliance from the plastic
bag and the carton.
– Place the appliance on the wall, turn on the power
switch, [I] means open, [0] means off. Plug into a
AC220-240V~ electrical outlet. There would be
a [BEE] sound and the [
The display would show the ambient temperature
and flash for 3 seconds.
Heating Preparation
Set time
– Before turning on the appliance, set the time as
the present time. Press the remote control [Lock]
button to light on control panel, it would show the
ambient temperature.
• WEEK setting: Press [Set] button one
time, [W] would light on, press [-] [+] buttons to
set the day from 1–7 (1 = Monday, 2 = Tues-
day... 7 = Sunday etc.)
• HOUR setting: Press [Set] button again, [ ]
would light on, press [-] [+] buttons to set the
Hour from 01–00 (01 = 1 o'clock, 02 = 2
o'clock... 00 = 24 o'clock etc.)
• MINUTE setting: Press [Set] button again, [
would light on, press [-] [+] buttons to set the
Minute from 00–59 (01 = 1 Minute, 02 = 2 Min-
ute etc.)
] light would be on.
]
PS: Press [Set] button, the numbers showing on the
screen would flash for about 5 seconds. You should
operate it in time, otherwise the appliance would get
back to standby mode. (The appliance would show
the present time until being powered off)
General Using Operation
– Turn the appliance ON by pressing the [
button, then the light [
ance would blow cold air and [
on.
– Press the [ ] button, the appliance would blow
warm air and both [ ] and [
– Press the [ ] button second times, the appliance
would blow hot air and both [ ] [
be on.
– Press the [ ] button three times, the appliance
would blow cold air and [
– Press the [ ] button, the appliance would set
timer from 01-24 hours and [D] light would be
on. [00] means the timer is off.
PS: The control panel [
ation as the remote control [24H] button.
24H Timer Function
– Power on the appliance as any working modes (It
can be fan, warm or hot mode). Control
panel [ ] button and remote control [24H] but-
ton have the same operation.
– Press [24H] button (or [
to set the timer. The timer can be set up to 24
hours. Keep pressing [24H] button (or [
control panel) to adjust the hours from 00–24 (00
= close, 01 = 1hour, 02 = 2 hours... 24 = 24 hours
etc.) and the [D] light would be on.
PS: [00] means the timer is off and the [D] light is off.
Thermostat Instructions
– Power on the appliance as any working modes (It
can be fan, warm or hot mode). This function can
only be operated by the remote control.
– To adjust temperature, press the [-] [+] to set the
desired temperature and the temperature can be
set from 10 °C to 49 °C.
– When the ambient temperature drops 2 degree
below the set temperature, the appliance would
start heating with [ ] (1000W).
– When the ambient temperature drops 4 degree
below the set temperature, the appliance would
start heating with [ ] (2000W).
– When the ambient temperature is ≥ the set tem-
perature, the appliance would blow the cold air
and [ ] light would be on.
Weekly Timer Function
– Power on the appliance as any working modes, (It
can be fan, warm or hot mode). This function can
only be operated by the Remote control.
– Set the time when the appliance starts operating:
• WEEK setting: Press [W.Timer] button first
time, [W] light would be on, showing [1] means
Monday.
• HOUR setting: Press [W.Timer] button 2nd
time, [ ] would light on, press [-] [+] buttons to
set the Hours from 01—00 (01 = 1 o'clock, 02 =
2 o'clock... 00 = 24 o'clock etc.)
GB
] main
] would be on. The appli-
] light would be
] lights would be on.
] lights would
] light would be on.
] button has the same oper-
] on the control panel)
] on the
25