SmartGyro RAPTOR Bedienungsanleitung Seite 10

EN
English
Alarm installation
smartGyro Raptor comes prepared to install the alarm in the most
comfortable and simple way. It is very important to perform all
operations with the skid off.
Step 1:
Open the battery cover. To do this, remove all the screws.
Step 2:
Once the lid is open, locate the next green terminated wire.
Step 3:
Connect the cable to the green connector on the alarm.
Step 4:
Attach the double-sided adhesive to the base of the alarm.
Step 5:
With the double-sided adhesive, stick the base of the alarm inside
the battery compartment, without hindering any other element
Step 6:
Put the battery cover back on.
1 2 3
4 5
9
Note: To uninstall the alarm perform all steps in reverse order.