Four Kinds Of Alarm Function; Lock Phase Function; The Function Of The Self-Set Frequency; Ups Led - ACT AC2300 Benutzerhandbuch

4.3 Four Kinds of Alarm Function

When AC fails, and the UPS supplies power, UPS will alarm once every 10
•
seconds and the beep stops about 40 seconds later.
• When the battery is nearly used up, the UPS will alarm automatically and the
beep frequency is once every 1 second.
Overload, when the UPS is overloaded, UPS will alarm once every 0,5 second
•
Fault, if there is a faulty operation of the UPS, UPS will alarm continuously.
•

4.4 Lock Phase Function

In AC mode, the UPS system automatically tracks AC phase and ensures that the
output wave form of the inverter is the same with AC voltage wave form. In this way, it
reduces the peak pulse and surge voltage to minimizes the interference and damage
to the equipment.

4.5 The Function of the Self-set Frequency

When the UPS is turned on for the first time, the acquiescence frequency is 50/60Hz;
when it is connected to AC, the frequency is automatically set to 50Hz or 60Hz in
accordance with AC.

5.0 UPS Led

LED indicator:
AC Mode Green LED is ON
Battery Mode Yellow LED is flashing
Fault mode Red light is ON

6.0 Installation and Operation

1. Shut down the load (for example PC)
2. Put UPS on the proper position
3. Connect load (for example PC) to the UPS
4. Put the plug to the AC power socket(make sure GND is connected well )
SUGGESTION: This UPS is the power supply for the computer, monitor and hard
disk(CD) etc. It has a limited backup time for the load, so you'd better not connect a
printer or other equipment to it.
5. Press the On/Off button on the UPS, the green LED and yellow LED will light up,
then you can turn on your computer etc.
Remark
：
1. Generally speaking, don't turn off the UPS so the battery keeps charging.
2. When AC fails the UPS will turn to battery mode. Please save important
documents in time.
6 |
ENGLISH