Insert The Batteries - TFA 35.1166.54 Bedienungsanleitung

TFA_No. 35.1166_Anleitung
Wireless weather station
B 3: –/MIN button
B 4: MAX/+ button
C: Housing (Fig. 2):
C 1: Wall mounting hole
C 2: Battery compartment
C 3: Table stand (removable)
Transmitter
D: Display (Fig. 3):
D 1: Channel 1,2,3
D 2: Transmission signal
D 3: Battery symbol for the transmitter
D 4: Outdoor temperature
E: Housing (Fig. 3):
E 1: Battery compartment
E 2: Support for wall mounting or table standing
E 3: Indentations for the holder for wall mounting
F: Buttons in the battery compartment (Fig. 3):
F 1: TX button
F 2: 1 2 3 switch for channel selection
5. Getting started

5.1 Insert the batteries

• Place the base station and the transmitter on a table at a dis-
tance of about 1.5 meters from each other. Avoid being close to
possible sources of interference such as electronic devices and
radio equipment.
• Open the battery compartment of the transmitter and insert two
new AA 1.5 V batteries, polarity as illustrated. All LCD segments
will be displayed for a short moment.
• The display shows the temperature. The switch is set to chan-
nel 1.
• Close the battery compartment.
• Open the battery compartment of the base station.
• Insert two new AA 1.5 V batteries, polarity as illustrated. All
LCD segments will be displayed for a short moment. The indoor
temperature appears on the display.
• Close the battery compartment.
04.07.2022 15:45 Uhr
– 28 –
Seite 15
Wireless weather station
5.2 Reception of outdoor transmitter
• The base station will scan the outdoor temperature and the
reception symbol flashes
• If the reception is successful, the outdoor temperature and the
reception symbol appear steadily on the base station display.
• If the reception of the outdoor temperature fails, "- -,-" remains
on the display. Check the batteries and try it again.
• You can also start the transmitter search manually later (e.g. if
the transmitter signal is lost or if the batteries are changed).
Press and hold the CHANNEL button on the base station for
three seconds. The reception symbol for the outdoor transmit-
ter will be flashing.
• Press the TX button in the transmitter's battery compartment.
The transmission of the outdoor data takes place immediately
and if the reception is successful, the outdoor temperature
appears on the base station display.
5.3 Reception of the DCF frequency signal
• After the reception of the outdoor values, the clock will now
scan the DCF frequency signal and the DCF symbol flashes on
the display.
• When the time code is successfully received after 3-10 minutes,
the radio-controlled time and the DCF symbol will be shown
steadily on the display.
• The DCF reception always takes place at 1:00, 2:00 and 3:00
o'clock in the morning. If the signal is not successfully received,
further attempts will be taken at 4:00 and 5:00 o'clock.
• You can also activate the DCF reception manually. Press the
–/MIN button for 3 seconds. The DCF reception symbol will be
flashing.
• Press and hold the –/MIN button again for 3 seconds to stop the
reception process. The DCF reception symbol disappears.
• There are 3 different reception symbols:
flashing symbol – reception is active
solid – reception is successful
no symbol – no DCF reception
• If the clock cannot detect the DCF-signal (e.g. due to interfer-
ence, transmitting distance, etc.), the time can be set manually.
• The clock will then work as a normal quartz clock (see "Manual
settings").
– 29 –