Sygonix 2368619 Bedienungsanleitung Seite 3

Operating Instructions
Portable Solar Wall Light
Item No. 2368619
Intended use
The product is a solar rechargeable light that can be wall mounted or separated for portable
use.
The product is intended for outdoor use. It has an ingress protection rating of IP65 and is
protected from dust and low-pressure water spray from all directions.
For safety and approval purposes, you must not rebuild and/or modify this product. If you use
the product for purposes other than those described above, the product may be damaged. In
addition, improper use can result in or other hazards. Read the instructions carefully and store
them in a safe place. Make this product available to third parties only together with its operating
instructions.
This product complies with the statutory national and European requirements. All company
names and product names are trademarks of their respective owners. All rights reserved.
Delivery content
• Product
• 2x wall plugs
Up-to-date operating instructions
Download the latest operating instructions at www.conrad.com/downloads or
scan the QR code shown. Follow the instructions on the website.
Explanation of symbols
The symbol with the exclamation mark in the triangle is used to indicate important
information in these operating instructions. Always read this information carefully.
This product is constructed according to protection class III.
The arrow symbol indicates special information and advice on operation.
Safety instructions
Read the operating instructions carefully and especially observe the safety
information. If you do not follow the safety instructions and information on
proper handling in this manual, we assume no liability for any resulting per-
sonal injury or damage to property. Such cases will invalidate the warranty/
guarantee.
a) General information
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. This may become dan-
gerous playing material for children.
• Protect the appliance from extreme temperatures, strong jolts, flammable gases,
steam, and solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, take it out of operation and
protect it from any accidental use. Safe operation can no longer be guaranteed
if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
• Please handle the product carefully. Jolts, impacts or a fall even from a low height
can damage the product.
• Consult an expert when in doubt about the operation, safety, or connection of the
appliance.
• Maintenance, modifications, and repairs must only be completed by a technician
or an authorised repair centre.
• If you have questions which remain unanswered by these operating instructions,
contact our technical support service or other technical personnel.
b) LED light
Attention, LED light:
• Do not look directly into the LED light!
• Do not look into the beam directly or with optical instruments!
• 2x mounting screws
• Operating instructions
c) Rechargeable battery
• The rechargeable battery is permanently built into the product and cannot be re-
placed.
• Never damage the rechargeable battery. Damaging the casing of the recharge-
able battery might cause an explosion or a fire!
• Never short-circuit the contacts of the rechargeable battery. Do not throw the bat-
tery or the product into fire. There is a danger of fire and explosion!
• Charge the rechargeable battery regularly, even if you do are not using the prod-
uct. Due to the rechargeable battery technology being used, you do not need to
discharge the rechargeable battery first.
d) Installation
• When drilling or tightening screws, make sure there are no cables, wires, or pipes
located underneath the surface.
• Inadvertently drilling through electric cables can cause life-threatening electric
shock!
Overview
3
4
1
1
2
Installation
a) Charging battery / location
Important
• Keep the panel clean to maximize charging efficiency. See section "Care and clean-
ing".
• Before first use, place the panel under bright sunlight for at least 5 hours to charge
the battery.
• Select a location where the solar panel receives the
• Do not place the product near other light sources such
• Battery status indicator:
b) Motion detection angle
Motion detection:
• Works best when the subject walks across the sensor.
• Does not work well behind glass.
1 Release tabs
2 Multi-function button (power / mode)
3 Solar panel unit
4 PIR sensor / battery status / mode indicator
most sunlight.
as streetlights. This will prevent the sensor from ac-
tivating.
- Green: ≥70 %
- Orange: 30 - 70 %
- Red:<30 %
120°