Auto Switch Off; Cleaning & Maintenance; Cleaning The Appliance - Ufesa SMART DIGITAL Bedienungsanleitung

WARNING: Do NOT direct the steam onto a garment that is being worn or at people or animals.
Can be used to remove creases from hanging clothes, curtains, etc.
1. Select "MAX" mode pressing the steam level selection button on the base (1) or on the handle
of the iron (3).
2. Hold the iron in an upright position 15 cm away from the garment to be steamed.
3. Press the steam release button (5) repeatedly with pauses of at least 5 seconds.

4. Auto switch off

For your safety and to save energy, the appliance switches off automatically when it has not been
used for 10 minutes. Six beeps will be heard, indicator light (1) will flash and icon will be
shown on the display.
To switch the steam station back on, press the steam release button (5) again. A beep will be heard.
CLEANING & MAINTENANCE
1. Iron lock
The easy carry locker attached to the base unit can be used to transport the steam Station with
ease. To do so, lift it in an upward motion until it clicks into position. Before using the Steam Sta-
tion, the easy carry handle must be locked back into position against the base unit; press and hold
the handle release button and carefully lower it back to place.

2. Cleaning the appliance

Turn off the Steam Station and unplug at the power outlet. Empty the water tank.
Regularly clean the ceramic soleplate with a damp, non-metallic washing pad. Wipe the exterior of
the Steam Station with a soft cloth.
Do NOT use abrasive cleaners, detergent or other chemicals to clean the Steam Station.
Regularly clean your appliance for properly maintenance.
Attention! Burn risk!
To keep the soleplate smooth, you should avoid contact with hard metal objects. Never use a scou-
ring pad, or chemicals to clean the soleplate.
3. Descaling process
It is recommended to perform the descaling process approximately every two weeks.
Proceed as follows:
1. Make sure that the water tank is full up to its maximum level.
2. Lean the iron horizontally on a water container.
3. Press the steam level selection button (3) and steam release button (5) together for several se-
conds. A long beep will be heard and icon will be shown on the display.
4. Keep the steam release button (5) pressed by means of its sliding blocking device.
Warning: boiling water and steam will be released through the soleplate, carrying limescale and/
or deposits that may be inside.
20