The Control Panel; Changing A Programme - Sharp QW-HX12U47ES-DE Bedienungsanleitung

7. . THE CONTROL PANEL

6
Rotate the Programme Selection Knob
(4) to switch on the machine and select a
suitable programme for your dishes. When
the Programme Selection Knob is in the
'Off' position, the machine will not operate.
Press the Start/Pause button (3) to start
the selected programme. The Start/Pause
light will switch off and the Wash light will
iluminate. If the door of your machine is
opened during washing, the Start/Pause
light will flash and the Wash light will remain
illuminated.
The Wash, Rinse, Dry and End lights (6) on
the Control Panel indicate the status of the
programme in operation. The machine will
remain silent for 40 to 50 minutes while the
Drying light is on.
The Remaining Time Indicator (1) shows
the duration of the selected programme
and the time remaining of the programme in
operation.
NOTE: Press the Half Load button
(2) to shorten the duration of the selecte
programme, and therefore reduce the
energy and water consumption.
NOTE: If an extra feature has been
used, such as Delay or Half Load (1, 2),
on the most recent wash programme,
this feature will remain active on the next
selected programme. To cancel this feature
on the newly selected wash programme,
turn the Programme Selection Knob to
the 'Off' position, then turn it to select a
programme. Extra features can be activated
with the newly selected programme.
NOTE: Simultaneously press the "+"
and "-" buttons for 3 seconds to activate/
deactivate the Child Lock. When it is first
activated, "CL" will show on the Remaining
Time Indicator for 2 seconds. When it is
deactivated, "CL" will flash twice.
5
aid, the Rinse Aid Lack Warning Indicator
(5) will illuminate, indicating the rinse ai
chamber needs filling.
Delaying a Programme
Before a programme starts, press the "+" or
"-" button on the Remaining Time Indicator
to delay the start time of a programme for
1 hour up to 19 hours. To change the delay
time, first press the Start/Pause button, then
use the "+" and "-" buttons to select a new
delay time. To activate the new delay time,
press the Start/Pause button. To cancel the
delay time, use the "+" and "-" buttons to
set the time to '0'.
Knob is turned to the 'Off' position after
the delay time has been selected and the
programme started, the remaining delay
time is stored. When the knob is turned to a
new programme, the remaining delay time
will resume.

7.1. Changing a Programme

Follow the steps below to change the
programme while in operation.
select the desired programme
EN - 20
NOTE: When there is insufficient rinse
NOTE: If the Programme Selection
Press the Start/Pause button.
After the programme stops,
using the Programme
Selection button.