Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Introduction
Introduction
The following guide will take you through the steps of setting up a DoorBird IP Video door
station in connection with a PEAKnx touch panel.
Please make sure that the PEAKnx touch panel receives an IP address and is connected to the
same local network your DoorBird IP Video door station is connected to. Please also make sure
that your DoorBird IP Video Station is online, using this service:
https://www.doorbird.com/checkonline
The local IP address of your DoorBird IP Video door station is available from the same page.
1 SIP server configuration
You can use a Fritzbox as SIP server or a SIP server software. This section shows how to set up
the Fritzbox and the Tek SIP software as a SIP server.
1.1 Option 1: Setting up the SIP clients in the Fritzbox
Setting up the PEAKnx Panel in the Fritzbox
1.
Open the browser and enter "fritz.box" into the address bar and log in to your Fritzbox.
2.
Navigate to Telephony > Telephony Devices.
3.
Go to "Configure new device", select the option "Telephone" in the next step and go to
"Next".
4.
Select "LAN/WLAN (IP telephone)", assign a meaningful name, e.g. "Controlmini" and select
"Next".
−
Enter the username and password for the PEAKnx Panel and note them for later use. Be
sure to give a secure password.
5.
Confirm the assigned phone number and select "Next".
6.
Select "Accept all calls" and "Next".
7.
You will get an overview, which you can confirm with "Apply". Press any button on the Fritz-
box to confirm the input for the router.
Setting up the Doorbird door intercom in the Fritzbox
8.
Under Telephony > Telephony Devices, go to "Configure new device" again and in the next
step select the option "Door Intercom System" and "Next".
9.
The connection is made via "LAN/WLAN (IP door intercom)".
10.
Assign a meaningful name for the door intercom and press "Next".
11.
Enter a username and password for the door intercom and note them down.
−
Special characters, umlauts or spaces should be avoided.
−
Be sure to give a secure password.
12.
For "Route doorbells to", select "Controlmini" from the drop-down list and go to "Next".
−
If this option does not appear in the selection menu, you can also select "telephone
16
Werbung
Inhaltsverzeichnis
