Important Safety Instructions - SMA SUNNY HOME MANAGER 2.0 Schnelleinstieg

2 Safety
It is possible to use the Sunny Home Manager in delta IT grids. When using the Sunny Home Manager in delta IT
grids, the cumulative power values are correctly measured. Due to the measuring principle of the
Sunny Home Manager, other measured values may be incorrect.
Statutory warranty
Use SMA products only in accordance with the information provided in the enclosed documentation and with the
locally applicable laws, regulations, standards and directives. Any other application may cause personal injury or
property damage.
Alterations to the SMA products, e.g., changes or modifications, are only permitted with the express written permission
of . Unauthorized alterations will void guarantee and warranty claims and in most cases terminate the operating
license. shall not be held liable for any damage caused by such changes.
Any use of the product other than that described in the Intended Use section does not qualify as the intended use.
The enclosed documentation is an integral part of this product. Keep the documentation in a convenient, dry place for
future reference and observe all instructions contained therein.
This document does not replace any regional, state, provincial, federal or national laws, regulations or standards that
apply to the installation, electrical safety and use of the product. assumes no responsibility for the compliance or non-
compliance with such laws or codes in connection with the installation of the product.
2.2

IMPORTANT SAFETY INSTRUCTIONS

Keep the manual for future reference.
This section contains safety information that must be observed at all times when working.
The product has been designed and tested in accordance with international safety requirements. As with all electrical
or electronical devices, there are residual risks despite careful construction. To prevent personal injury and property
damage and to ensure long-term operation of the product, read this section carefully and observe all safety
information at all times.
Danger to life due to electric shock when live components or cables are touched
High voltages are present in the conductive components or cables of the product. Touching live parts and cables
results in death or lethal injuries due to electric shock.
• Disconnect the product from voltage sources and make sure it cannot be reconnected before carrying out any
work on the product.
• Before carrying out any work on the product, disconnect the grid side from all voltage sources using the
installed disconnect switch.
• Ensure that the conductors to be connected are de-energized.
• Clean the product with a dry cloth only.
• Only use the product in a dry environment and keep it away from moisture.
• Install the product in the switch cabinet only and ensure that the connection areas for the line conductors and
the neutral conductor are behind a cover or have contact protection.
• Observe the prescribed minimum clearance between the network cable and live installation components, or
use suitable insulation.
6 HM-20-IS-xx-21
DANGER
SMA Solar Technology AG
Quick Reference Guide