Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 27
– If the kettle was removed from the stand during boiling, remains in ON position.
This means that if you put it back on the stand, it will immediately continue in heating.
IV. MAINTENANCE
Unplug the appliance from power supply by taking the fork of the power cord out of the
socket! Clean the kettle only when it is cooled down! Do not use rough and aggressive
detergents (e.g. sharp objects, scrapers, diluting agents or other solvents)! The casing of the
electric kettle is made of top-quality plastic material and the heating bottom is made of top-quality
stainless steel, but in common use, impurities from water get stuck on them (water scale),
particularly above the heating element. It is not rust or another material defect of the kettle
container and the appliance is not subject to a complaint for this reason.
Cleaning the sieve (A7)
Take the sieve from the kettle. Clean it from possible sediments in running water using a fine brush.
Then put the sieve back in the opposite way.
Cleaning the kettle
In the hard water area, it is important to do the decalcification regularly to keep the kettle in good
working condition, because too much scale inside may cause the kettle fail to work. For the best
performance of your kettle, decalcify the unit from time to time. The frequency depends on the
hardness of your tap water and how many times you have used the kettle. Decalcification will clean
the interior of the unit.
This may be done in the following manner:
Put about 50 g of citric acid into the kettle with limescale sediment. Fill the kettle half with water and
stir. After dissolving, fill it up to ¾ of maximum amount of water. Place the kettle on the stand and
turn on. Turn off the kettle before reaching boiling point, let the solution work for 10 minutes and
then pour it out. Rinse the kettle thoroughly with clean water. In case of very thick sediments, you
can repeat the process. Clean the kettle regularly!
V. TECHNICAL DATA
• Input 1630 W
• Max. capacity 1.0 liters
• Weight (kg) approximately 0,7
• Protection class of the appliance I.
• Size, (cm) 21 x 21 x 14
• Input in off mode is 0.00 W
Expert service must do the large maintenance or to intervene into inside parts of the
appliance! Non-observance of the instructions of the manufacturer cancels the right for
guarantee repair!
VI. LEGISLATIVE & ECOLOGY
The manufacturer reserves the right to change the technical specifications and accessories
for the respective models.
WARNING: Do not use this product near water, in wet areas to avoid fire or injury of electric
current. Always turn off the product when you don't use it or before a revision. There aren't
any parts in this appliance which are reparable by consumer. Always appeal to a qualified
authorized service. The product is under a dangerous tention.
20 / 31

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis