General Safety Instructions - Ritter ESM 50 Gebrauchs- Und Montageanleitung

GENERAL SAFETY
INSTRUCTIONS
To avoid personal injury or
damage to the appliance, please
observe the following safety
instructions:
– The hand blender is to be
used for domestic purposes
only and must not be used
commercially.
– Assembly (see page 18 or
the QR code on the cover)
must be performed by quali-
fied personnel only. ritterwerk
will not be held liable for the
consequences of improper or
incorrect assembly.
– Do not start using the hand
blender until it has been
assembled by a professional.
– The power cord must be
routed in such a way that it
is not pinched and can run
directly and without obstruc-
tion from the built-in system
to the socket to be installed in
the floor cabinet.
– Route the power cord so that
it does not come into con-
tact with hot or sharp-edged
objects. Do not bend it or wind
it around the appliance. Do not
allow the power cord to hang
down over the edge of the
worktop.
– The hand blender's motor
unit (2), the charging sta-
tion (13) and the plug-in power
supply (15) must not come into
contact with heat, fire, mois-
ture or dirt.
– The blender shaft (3) must not
come into contact with heat,
fire or dirt.
– Only connect the plug-in
power supply to a suitable AC
power source that complies
with the specifications on the
type label.
– Only use the charging sta-
tion, plug-in power supply and
accessories supplied with the
blender. The appliance must
only be operated using its orig-
inal parts and accessories.
– If all 4 LEDs are flashing
continuously at the same time,
this indicates a serious elec-
tronic fault. This can represent
a safety hazard when chang-
ing the attachments or acces-
sories and spare parts and
during cleaning. Stop using
the appliance immediately and
have it inspected at an author-
ized service location. Never
touch the attachments. It is no
longer possible to charge the
battery in this case.
English
11