5 C C H H A A N N G G I I N N G G T T H H E E I I N N D D E E X X A A B B L L E E I I N N S S E E R R T T S S - Mapal Hpr400 Montage- Und Betriebsanleitung

4 4 . . 2 2 T T o o o o l l s s a a n n d d m m a a t t e e r r i i a a l l s s r r e e q q u u i i r r e e d d
• TORX®-screw driver IP15
• TORX® torque wrench IP15
• Protective gloves
• Compressed air blow gun
5 5 C C h h a a n n g g i i n n g g t t h h e e i i n n d d e e x x a a b b l l e e i i n n s s e e r r t t s s
EN
EN
Fig. 2: Releasing the clamping screw
Fig. 3: Removing the insert
16
16
C C A A U U T T I I O O N N
S S h h a a r r p p c c u u t t t t i i n n g g e e d d g g e e s s o o n n t t h h e e t t o o o o l l ! !
Sharp cutting edges may cause cutting injuries.
 Wear protective gloves when changing inserts.
Clean the tool before beginning to
change the inserts.
Release the clamping screw with the
suitable TORX®-screw driver, to do this
rotate the screw anti-clockwise.
Remove the clamping screw.
Carefully slide the insert up the insert
pocket and remove the insert.
I I N N F F O O R R M M A A T T I I O O N N
When exchanging an insert all in-
serts must be exchanged!
Remove the remaining inserts.
Montage- und Betriebsanleitung
Montage- und Betriebsanleitung
Installation and Operating Instructions
Installation and Operating Instructions