Safety Instructions - Anker Rk10 Betriebsanleitung

2.3. Safety instruction
Failure to comply with the following safety in-
structions may result in physical injury or damage
to the ANKER RK10.
• All persons handling the ANKER RK10 must
be familiar with the operating manual and its
location.
• The ANKER RK10 may only be used for its
intended purpose.
• The ANKER RK10 must be checked at least
once a day for externally visible damage and
defects.
• In case of visible defects or damage, the
product must not be put into operation or
must be taken out of operation immediately.
• The electrical equipment must be checked
regularly in accordance with the legal health
and safety requirements.
• Loose connections, defective cables etc. must
be replaced immediately.
• Only carry out work after disconnecting from
the power supply.
• Cables must not be pinched or crushed.
Please follow the enclosed documentation(s) of
the electronic components and/or other acces-
sories!
• The legal regulations must be followed for all
work on the product.
• Repair work may only be carried out by
appropriately instructed specialists.
• The ANKER RK10 complies with the relevant
safety regulations for information technology
equipment and may only be used in systems
which also comply with these requirements.
• This product complies with the „Law on the
Electromagnetic Compatibility of Equipment"
EMVG - This is the implementation of the EU
directive.
• The ANKER RK10 complies with the EU
directive on RoHS conformity.
• This device is entitled to bear the EC confor-
mity mark LZ-CE - in accordance with the
German EMVG.
BETRIEBSANLEITUNG // OPERATING MANUAL page 29