Blade Sharpening - Lacor 69125 Gebrauchs- Und Instandhaltungsanleitung

3.- Pusher axle lubrication;
a- Clean the pusher axle with dry cloth first.
b- Put the lubricant on the both of the axles and pull the pusher up and down to make
the lubricant well spread and the pusher work well.
c- It is best to lubricate the axle every day.
4.- Sharpener lubrication
a- Clean the sharpener axle before sharpening.
b- Put the lubricant on the both of the axles.
c- Turn around and slide the axle until the axles move well.
5.- Localizing head lubrication;
a- Turn the fixing positioner on the counterclockwise to the max length.
b- Clean the localizing head and put on some lubricant.
c- Turn the fixing positioner back to the original position
d- It is best lubricate it every week and do not use too much oil.
1.- You should sharpen the blade when the slice thickness is not even or the slices are not
continuous.
2.- Clean the edge of blade before sharpening.
3.- Pull the sharpener out and lubricate the sharpener axles so that it works well.
4.- Pull the sharpener out and turn 180º, press right side stone down by finger then put the
sharpener to the working position.
5.- Make sure that the surface of stone is resting closely to the surface of edge. If not, please
adjust it.
6.- Turn the power on and the work the blade 10-15 seconds. Stop the machine look and see if
the blade is sharpened well. If not, continue running the machine some more time.
7.- Press the left side stone down and make sure the surface of stone is resting closely to the
surface of blade, then sharpen 3 seconds to remove a burr.
8.- Put the sharpener back to the original position when done.
9.- Always keep the stones clean as the stones work best when cleaned.
10.- Wear approved safety eyewear when sharpening the slicer knife to avoid the possibility of
any eye damage during the sharpening process.
Chasse

BLADE SHARPENING

Pêche Loisir et nature
www.ducatillon.com
41
Jardin Élevage