Cleaning; Maintenance - Lacor 69125 Gebrauchs- Und Instandhaltungsanleitung

4.- Before machine first use and before plug, clean carefully the blade and all parts that might be
in contact with food.
5.- Make sure that the line voltage of your power source matches the rated voltage and frequency
on the machine.
6.- Turn the switch on and let the machine race about 2-3 minutes before use. Look to see that
the machine is running properly before use.
7.- When the power is on, the light bulb on the power button will glow.
8.- Adjust the slice thickness by turning the slice thickness regulator counterclockwise. Turn the
positioner knob clockwise. Make sure the positioner head touches the plate.
9.- Push the product carriage back and forth over the blade with a continuous motion, using the
product pusher handle and the pusher knob.
10.- After slicing the desired amount turn the positioner knob back to the original position.
11.- You can now pick up the sliced product.
1.- Always turn off and unplug the machine before cleaning, and make sure to turn the slice
thickness regulator to zero position to avoid cutting yourself.
2.- Never use any chemical or abrasive products. Do not use a brush or any other type of
utensils which could damage the different parts and surface of the slicer.
3.- Use a damp cloth with detergent to clean the machine and then dry it. Make sure to clean
the machine completely every day.
4.- Removing the blade cover away from the blade when cleaning, and clean the product
carriage also.
5.- Warnings for blade cleaning:
a- Wear a safety glove when the slicer is in operation.
b- Do not touch the edge of the blade.
c- This is a dangerous operation use caution and be careful.
6.- You should run the machine 5 minutes after cleaning.
ATTENTION:
7.-
1.- Minimizing blade rust:
a- Wipe the blade with a dry cloth at the end of each shift or day.
b- Spread a layer of cooking oil on the edge of the blade with dry cloth.
c- Sharpen the blade every day to prevent rust.
2.- Guide lubrication;
a- Push the carriage to one side, and clean the grease dirt of the guide with dry cloth.
b- Smear the guide surface with lubricant. Spread well and lubricate.
c- It is best to lubricate the guide every week.
40
Chasse

CLEANING

Do not put the machine directly into any container with water in it.
This machine is not waterproof.

MAINTENANCE

Pêche Loisir et nature
www.ducatillon.com
Jardin Élevage