Recommended And Front Line Spare Parts - MBM MC201E Bedienungsanleitung

Message on the screen
i31 : Electronics overheating: Temperature
reduced to 180°C
i33 : Core probe non function or not plugged in
i81 : Water flow problem
i82 : Sticking solenoid
E46 : Electronic communication fault
E53 : Ventilation non function
E61 : Ambient probe short circuit
E62 : Ambient probe non function
E68 : Cavity at +290°C
E72 : Electronics at over + 75°C
E73 : Detergent pump faulty or on permanently
3B-390977NU – 10/18
1 way 1 x 10 L/min solenoid valve
Drive shaft gasket + wear ring
Complete mounted sensor sub-assembly of oven generator
2 way 2 x 10 L/min solenoid valve
3 way 3 x 10 L/min solenoid valve
3 way 2 x 10 L/min + 1 x 5 L/min solenoid valve
Sub assembly - Gas valve without safety enclosure
Starting electrode
After sales kit 9kW element 340 dia + seal
After sales kit 15kW element 500 dia + seal
After sales kit 9kW element 430 dia + seal
After sales kit 7.5kW immersion heater 380 long
After sales kit 6kW immersion heater 380 long
After sales kit 24kW immersion heater 570 long
After sales kit 17.7kW immersion heater 570 long
After sales kit 8kW immersion heater 380 long
4 way solenoid valve, 2 x 10 L/min + 2 x 5 L/min
Reed switch
Three-pole 25A 230V 50/60 Hz contactor
Three-pole 32A 230V 50/60 Hz contactor
Three-pole 40A 230V 50/60 Hz contactor
Three-pole 50A 230V 50/60 Hz contactor
Three-pole 80A 230V 50/60 Hz contactor
Anti-interference relay
Ultra fast fuse 0.2A 250V 5 x 20
10amp 5 x 20 fuse
PT100 sensor, diameter 4, 350 in length
2 points PT 100 regulating sensor
Gas generator probe
1 point regulation probe, PT 100
Axial fan
LN2 fixed centrifugal fan 7000rpm
Motor
Condenser 12.5µf
Reducing gear with centre return spring, 85 degrees
3 phase 125A fuse holder
3 phase 50A fuse holder
14 x 51 32A GG fuse
22 x 58 63A GG fuse
Switching regulator 15V 15W RS 15-15
Fuse 3.15 Amp
Inter card cable
17 ERROR MESSAGES
Consequences
Cooking continues automatically
at a temperature below 180°C
Cooking stops
Reduced functionality or Pause
the cleaning
Reduced functionality
Cooking stops
Cooking stops
Cooking stops
Cooking stops
Cooking stops
Cooking stops
Drain the hydraulic circuit.
Reduced functionality

18 RECOMMENDED AND FRONT LINE SPARE PARTS

Designation
Clean the lower and rear air intakes. If the problem
persists, call a service technician.
To continue cooking connect a probe or switch to timer mode.
Check the valve and water pressure.
If the message appears during a cleaning cycle it is
possible to stop the cycle if the cleaning chemicals have
not yet been injected, by pressing stop. Check that the
water has not been switched off to recommence the cycle
automatically. If this is not the case the cycle is blocked.
To force an end to the cycle :
- press on « Tools/Cleaning »
- enter the PIN code « RSTC » to exit
- manually undertake a thorough rinse of the cooking
cavity to eliminate all chemical residues before
cooking
- call a service technician
Switch off and call a service technician.
Possible to launch safe mode: convection mode at 175°C
(see guidance and info about the control screen).
Switch off and call a service technician.
Switch off and call a service technician.
Switch off and call a service technician.
Switch off and call a service technician.
Switch off and call a service technician.
Switch off and call a service technician.
Page 13
Codes
144937
145587
147060 / 147061
147152
BONNET GRANDE CUISINE
147723
Rue des Frères Lumière - Z.I Mitry Compans
147792
77292 MITRY MORY Cedex
148222
148223
148752
148753
148754
148756
148757
148758
148759
148760
148770
300676
300697
300698
300699
300700
300702
300769
300787
300788
301456
301471
301479
301485
304194
304276
304292
304293
305108
307468
307469
307471
307472
308350
- 12 -
309407
309581
What to do?
Equajet Equajet Boiler
x x
x x
- x
x -
- x
x -
x x
x x
x x
x x
x x
- x
- x
- x
- x
- x
- x
x x
x x
x x
x -
x x
x -
x x
x x
x x
- x
x x
- x
x x
x x
x x
x x
x x
x x
x x
x x
x x
x x
x x
x x
x x
EN