Herunterladen Diese Seite drucken

INTEZZE CUBE Bedienungsanleitung Seite 2

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 3
EN - SIMPLE OPERATING INSTRUCTIONS
TURNING THE EARPHONES ON/OFF
Before you begin using the earphones, remove the protective film from the charging
pins. Both earphones turn on automatically after removal from the charging case. The
LED lights then blink alternating blue and red. This means that you can pair the
earphones with your phone. When you return them to the charging case, they turn off
automatically. The earphones can also be turned on manually by pressing the multi-
function button for three seconds. The LED lights will blink blue. The earphones can also
be turned on manually. Just hold down the multifunction button for four seconds (the
earphones must be disconnected from your phone first). The LED lights will blink red.
Turning off automatically – when the earphones disconnect from a device, they turn off
after five minutes on their own.
EARPHONE FUNCTIONS
Volume – Up/Down
Volume + : One short press of the right earphone
Volume - : One short press of the left earphone
Answering a call:
One short press of either earphone
Ending a call:
Double-press either earphone
Rejecting a call:
One long, 2-second press of either earphone
WARRANTY CONDITIONS - THE WARRANTY DOES NOT COVER THE FOLLOWING SITUATIONS:
1.
Damage caused by unauthorised tampering with the device.
2.
Filters clogged by earwax (may not be immediately visible) or otherwise needing cleaning. Cleaning
must be done by an authorised service and a fee is charged.
3.
Earbuds with their duct filters removed.
4.
Physical damage to the earbuds caused by a fall or impact.
5.
Damage caused by force majeure.
Play/Pause:
Double-press either earphone
Next song:
One long, 2-second press of the right
earphone
Previous song:
One long, 2-second press of the left
earphone
CAUTION
1. To enable connection of the charging pins, you must first remove the protective film from the pins on
the earbuds.
2. Fully charge the case together with the earbuds prior to first use.
3. If you are not using the earbuds for an extended time,
keep charging the earbuds and case regularly, to avoid damaging the batteries (shortening their
lifespan).
4. Keep the volume at the lowest possible level.
Listening at loud volumes for an extended time may damage your hearing irreversibly!
5. Children must be supervised by an adult when using the earbuds. Risk of swallowing small parts.
6. Clean using a slightly damp cloth only.
7. Do not use the earbuds outside their supported temperature range of -15°C to +50°C.
8. Do not charge the case or earbuds in places with a temperature below 0°C.
9. Do not expose the earbuds or case to direct sunlight for extended periods.
10.Never disassemble or otherwise try to repair the earbuds.
11.Keep the mesh on both earbuds clean to avoid sound quality degradation.
12.Using the headphones in a dusty or humid environment can damage them.
SPECIFICATIONS
Bluetooth version: 5.1
Driver diameter: 10 mm
Sensitivity: 117 ± 3 dB
Impedance: 32 Ω ± 15%
Frequency range: 20 Hz - 20 kHz
Signal range: 10 m
Earphone battery capacity: 30 mAh
Case battery capacity: 300 mAh
Protection level: IPX4
Charging connector: Type-C
Content subject to change
Complete instructions can be found at www.intezze.com
EN
Please remove the sticker on
the back of the earbuds for a
better visual experience
Support contact
info@intezze.com

Werbung

loading