Samson RS Serie Bedienungsanleitung Seite 9

Bluetooth Pairing
®
1. Turn the BLUETOOTH/AUX IN Volume control
down counterclockwise to 0.
2.
With the RS Loudspeaker and your Bluetooth
device powered on, quickly press and
release the Pair button on the rear panel of
the RS Loudspeaker to make the speaker
discoverable. The Bluetooth indicator will
slowly flash blue.
3. In the settings of your Bluetooth device, set it
to "discover" available devices.
4.
From the Bluetooth device list, select the
"Samson BLUETOOTH" device.
5. If your device asks for a passkey, enter digits
0000 (four zeros) and press OK. Some
devices may also ask you to accept the
connection.
6.
The RS Loudspeaker speaker indicates that pairing is complete when the indicator turns
steady blue. You can now stream audio from your device to the RS Loudspeaker.
7. With the volume control on your Bluetooth device turned up, play some music, and slowly
raise the RS Loudspeaker BLUETOOTH/AUX IN Volume control until you have reached the
desired level.
Voltage Selection Instructions
Following are step-by-step instructions
for changing the mains voltage of the RS
Loudspeaker.
WARNING: Before carrying out this operation,
remove the power cord!
1. Insert a small screwdriver into the slot
beneath the fuse sled and gently press
in and up. The fuse sled will pop out
approximately 3/8" inch.
2. Remove fuse sled.
3. Remove the fuse. Replace with the
correct fuse for your region.
4. Rotate the fuse sled and line up the
arrow on the AC inlet with the correct
voltage for your region.
5.
Push the fuse sled into the AC inlet
until fully seated.
RS Active Loudspeakers with Bluetooth
USE ONLY WITH A 250V FUSE
EMPLOYER UNIQUEMENT
AVECUN FUSIBLE DE 205V
110–120
USE ONLY WITH A 250V FUSE
EMPLOYER UNIQUEMENT
AVECUN FUSIBLE DE 205V
110–120
®
220–240
220–240
9