Peach PS500-30 Bedienungsanleitung Seite 8

paper jams.
Do not shred wet paper, carbon paper or plastic bags.
●
The remains will jam the cutterbar, which can lead to
jams and reduced performance of the machine.
Although the document shredder is capable of
●
shredding staples, you should remove them. Paper
clips and industrial staples must be removed.
Trouble-shooting
Paper jam:
In the event of a paper jam, the machine stops
automatically and starts reverse operation. The paper is
released again. The signal lamp "Overheat/Overload "
flasches red.
Set the switch 1 to position "REV" and remove the
●
jammed paper.
Reduce the number of pages and restart.
●
Overheating:
If you use the unit for more than 4 minutes continuously
with maximum load, it switches off automatically. The
"Overheat/Overload" 3 signal lamp lights red. The
unit can be used again after a waiting period of approx.
40 minutes.
Overloading:
If you exceed the maximum shredding capacity of
2
8 sheets ( 80 g/m ) in one operation the machine
will switch off automatically. The "Overheat/Overload"
signal lamp lights red. Remove the excess paper
3
and try again. The machine might be overheated at
the same time, in this case turn off the unit and let
it cool down approx. 40 minutes.
Cleaning and care
Occasionally insert some oiled paper into the paper
opening and run the unit in "FWD mode" for about
10 seconds. Use PEACH Oiled Paper PS100-00 (or
alternatively PEACH Paper Shredder Special Oil PS100-
05).
The outside of the unit can be cleaned with a damp cloth.
Do not use solvents or flammable materials for cleaning.
4
Disposal
Guideline 2012/19/EU concerning the
handling, collection, recycling and
disposal of electrical and electronic
equipment and their components ('waste
electrical and electronic equipment',
known as WEEE).
The crossed symbol on a waste container indicates
that the machine or appliance must not be disposed
of with household waste, but must be handed over to
an appropriately equipped collection point for proper
disposal.
Directives
3
We declare that this device has been
manufactured in accordance with the
applicable rules and regulations.