Technical Specifications - Berner DM8 Bedienungsanleitung

EN
Functions
1. ON / continuous measurement / measuring button
2. Function Button (volume, area, etc.)
3. Reference point button, unit button
4. + / - button / memory button
5. Delete/OFF button
6. Display
7. Battery compartment
Operation
• The measuring device is switched on by pressing the „ON" button (1).
• The measuring device is switched off by pressing and holding the „CLEAR / OFF"
button (5).
• Briefly pressing the „CLEAR / OFF" button (5) deletes the last measurement data
and the measuring device goes back to the basic position.
• The reference point of the measuring device can be changed by briefly pressing the
"UNIT" button (3). The unit of measurement can be changed by long pressing the
"UNIT" button (3). (mm, in, ft)
• If the measuring device is switched on and the „ON „button (1) is pressed briefly,
a single measurement is carried out. If the „ON" key is pressed for a long time, a
continuous measurement is triggered. The MIN and MAX measured values also
appears in the display.
• You can switch between the individual functions by pressing the „FUNC" button (2).
Area measurement, volume measurement, area summation and Pythagoras
1,2 and 3. The corresponding function is shown in the display
• To query the measured value memory (max. 50 data), press and hold the „FUNC"
button. appears in the display the memory icon. The last 50 measured values can be
called up with the +/- button (4).

Technical specifications

Recommended Operating
Environment:
Measuring range:
Measurement accuracy:
Dimension:
Recommended target:
Laser beam class and type:
Protection class:
Automatic shutdown (device):
Automatic shutdown (laser):
Battery:
10
Laser Distance Meter
Operation Manual
%~80% relative humidity, at an altitude
of 0~2000m
0.5 - 100m
±2mm
117 x 52 x 27mm
White wall or piece of white A4 paper
Class-II, with the wavelength 620~670nm
and max. output power of 1mW
IP41
3 minutes
30 seconds
3V DC (2 x 1.5V "AAA" batteries)