Installation Overview - Tektronix P7700-Serie Installations- Und Sicherheitshinweise

Active tip with TekFlex, P77HTFLRB (high temp)
Active tip, P77STFLXB

Installation overview

CAUTION: To avoid ESD damage to the probe, always use an antistatic wrist strap (provided with your probe), and work at a
static-approved workstation when you handle the probe.
1. Connect the probe to the host instrument.
If it is the first time the probe has been connected to the oscilloscope, the oscilloscope will download the S-parameters stored in the
probe and cycle through the LEDs. Once the oscilloscope has stored the S-parameters for the probe, it doesn't matter which channel
the probe is plugged into. The stored S-parameters will be available for any channel the probe is moved to.
2. Connect the probe tip to the TekFlex connector on the probe.
When a tip is inserted into the probe for the first time, the oscilloscope will download the S-parameter data stored in the tip.
3. The probe performs a self test, and then one Input Mode LED remains on. The Status LED is also lit green.
4. Open the Calibration menu (found in the Vertical menu).
5. Double-tap the channel badge to open the configuration menu.
6. Tap the Probe Setup panel to open the Probe Setup panel to confirm probe settings.
7. Perform the DC probe calibration procedure using the optional DC probe cal fixture. See
8. Use the Probe Setup screen Probe Setup panel to set the probe parameters as described in the Basic operation section.
Get to know your Browser
Assemble the Browser
1. Insert the TekFlex connector. Pinch to open the collar.
P77C292MM, 2.92 mm adapter
TriMode probe DC
Installation overview
compensation.
5