Hofmann Compact CO5000 Bedienungsanleitung Seite 13

2. Setting up the scale
CAUTION
Avoid installing the scale in direct sunlight, that may cause
discoloration or malfunctions. Place your scale on a firm weighing table
so that the scale is level. (The scale will not perform accurately when it
is not level.)
Place the scale on the firm surface that is flat and level for an
accurate weighing.
WEIGHING AND COUNTING
Before weighing and counting
Whenever possible, please allow the balance to warm up for 10
minutes after first turning power on, so that the balance will function
properly and accurately.
Error messages
EEEE: Overload
: Low battery
Calibration may be required before weighing.
Read "CALIBRATION" first and if necessary, calibrate your scale for
accurate weighing.
Weighing procedures
1. Press [I/O] to turn on the scale.
When power is turned on, all display segments appear on LCD for a
few seconds and finally "0" will appear on the display.
2. Select the weighing unit with [MODE].
Press [MODE] to select a weighing unit, eg. "g" ....
Once the unit has been selected, the selected unit will be displayed
to the weight value.