Operating Manual; Introduction; Scope; Service - Åkerströms SESAM 800 Bedienungsanleitung

OPERATING MANUAL

OPERATING MANUAL

1 INTRODUCTION

This manual only covers the installation of the Sesam radio remote system. The Sesam system
is not a complete remote control system; it provides only the set of outputs that are driven ac-
cording to the actions performed by the operator of the transmitter. The way the set of outputs
is used for controlling the object depends on the specific installation and is outside the scope of
the Sesam.
The approvals for the Sesam radio remote control system are only valid for the system itself.
The complete remote control system, where the controlled object is one part, has to be tested
and approved according to the standards/norms that are applicable and specific to the controlled
object, it is not the responsibility of Åkerströms Björbo AB. No liability for the controlled
object or the controlled objects actions will be accepted by Åkerströms Björbo.

2 SCOPE

The following guide must be used when installing Åkerströms Sesam remote control system to
ensure secure, safe operation. The installation must be carried out by a certified electrician.
= This symbol highlights extremely important information.

3 SERVICE

Contact your Åkerströms Björbo AB dealer for service or support. Warranty work must be
performed by Åkerströms or authorized service center.

4 MAINTENANCE

For cleaning use a dry cleaning cloth, if necessary use a wet cleaning cloth and a soap solution.
Never use an alcohol-based product for cleaning; it can seriously damage the plastic. Do not use
pressure washer on the product!
Document-ID: 947422-000 Multi
5 (112)
EN
Version: C0